5 replies to this topic

[somesortofthing]

I've started up a new world with the newest Direwolf20 pack, but I've run into a problem. Whenever I try to pour a weapon part into a cast, the faucet doesn't turn on. I've tried to do this with iron and copper already, and neither has worked. I can pour blocks and ingots just fine, but weapon parts just don't do anything. Has anyone else run into similar problems?

 

[Aezex]

How about a screenshot of your setup?

 

Just to make sure, you are pouring the liquid into a cast of a part, not an actual part? 

[somesortofthing]

Yes, I am pouring a liquid into a cast, not onto a part. http://imgur.com/a/HNMeR Here's my setup. For some reason, the ingot cast's stopped working too, though the casting basin does continue to work as intended. I know that the iron isn't in the right place for pouring and there's not enough of it, I was pouring copper at the time. The basin and table is floating because of recent creeper attacks.

[felinoel]

There might be a trace amount of a different liquid in it already, that would prevent you from pouring this.
Pick it up and then try it again? By picking it up that empties any liquid currently in it.

[Daoev]

Try using a fluiduct.

[timrem]

I know that the iron isn't in the right place for pouring and there's not enough of it, I was pouring copper at the time.

Are you sure you have enough Copper in there? It appears as though you have about as much Copper as you do Iron (about 3 ingots' worth), and if you're trying to pour into that large blade cast, you'd need 8 ignots' worth.

 

Also, be sure to hit the faucet a couple times if you've used it recently and it didn't work. Sometimes, you can turn a faucet 'on', but it won't pull anything, and the next time you hit it for a different operation, you turn it 'off' instead of activating it normally.